WORK Varianza T1S 18x8J/9J Deep Rim Wheels Set - Crown, Cima, Mark X, Soarer

This listing is for a discontinued, hard-to-find set of four WORK Varianza T1S wheels in 18-inch diameter, 8J front and 9J rear, +45 offset, hub bore 73mm, PCD114.3 5-hole, chrome finish. Measured rim width is about 55mm front and 70mm rear, giving a deep-dish look. Caliper clearance is about 25mm, so big brake calipers will not fit. The seller notes these look clean at a glance but on closer inspection there is some peeling and corrosion in the chrome plating, and there were some rim scratches that have been touched up so they are not very noticeable. All four wheels were spin-checked with no problematic wobble found. Fitment is stated for Toyota Crown, Crown Majesta, Nissan Cima/Cedric/Gloria, Toyota Soarer, Aristo, Mark X, and Chaser, though the seller advises buyers confirm fitment themselves using the stated dimensions, as some vehicles may require lowering. No tires are included, only the bare wheels.

Seller describes some scratches and dirt overall, with chrome plating showing peeling and corrosion in spots on close inspection, though prior rim scratches were touched up to be less noticeable. All four wheels were spin-tested with no problematic wobble found.

Shipping: Confirmed domestic shipping to the Osaka consolidation point is 3,900 JPY via Sagawa Express. The seller also offers cash-on-delivery (Sagawa eCollect) with an additional COD handling fee, and notes freight-collect shipping is possible as an alternative to prepaid.